Coleccionistas y restauradores de pinball/petacos

New MPU-C for Playmatic

« Older   Newer »
  Share  
view post Posted on 7/4/2019, 09:29

Aficionado pinbolero

Group:
Member
Posts:
59

Status:


I built a cpu board for few Playmatic pinballs (Antar, Attack, Black Fever, Evil Fight et Zira ). Board tested in one pinball ( Attack ) It’s like the MPU-C with the same components. All the chips is on sockets. If there is a problem it’s very easy to change the chip. There are three LED to verify the signals ( +6v, INT and SYNC ) . There are two 2716 eprom.
You can only buy the PCB: 50 euros. Available
You can buy the PCB with all the components except all the chips. All the solders are done: 80 euros. Available
You can buy the PCB with all the components with all the chips: 110 euros. Available soon.
For the eprom I use the files from internet so I am not sure the files are good. For the moment I am sure for Attack.
If you have any question, contact me.
Have a good day.
Michel

photos_carte_cpu_playmatic
 
Top
0 replies since 7/4/2019, 09:29   618 views
  Share